Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Alienware Aurora R15 Service Manual

PDF

Installing the VR heat sink

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

NOTE:Before installing the new VR heatsink, ensure to remove the protective foil from the thermal pad.

About this task

The following images indicate the location of the VR heat sink and provide a visual representation of the installation procedure.

Image: Installing the VR heatsink

Image: Installing the VR heatsink

Steps

  1. Align the captive screws of the VR heat sink with the screw holes on the system board.
  2. Tighten the two captive screws that secure the VR heat sink to the system board.
  3. Repeat the same procedure for the other VR heat sink.

Next steps

  1. Install the left-side cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\