- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Base cover
- Battery
- Memory modules
- Solid-state drive—M.2 slot one
- Solid-state drive—M.2 slot two
- Solid state drive—M.2 slot three
- Solid state drive—M.2 slot four
- Solid-state drive interposer board
- Wireless card
- Hard drive
- Rear-I/O cover
- Audio daughter-board
- Speakers
- Card-reader board
- Coin-cell battery
- Computer base
- Touchpad
- Display assembly
- Heat-sink assembly
- Processor
- Graphics card
- Left power-adapter port
- System board
- Right power-adapter port
- Keyboard
- Palm-rest assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Alienware
Alienware Area-51m R2 Service Manual
Removing the M.2 2280 solid-state drive from M.2 slot four
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the base cover.
About this task
NOTE: This procedure applies only to computers shipped with an M.2 2280 solid-state drive installed in M.2 slot four.
The following image indicates the location of the M.2 2280 solid-state drive in M.2 slot four and provides a visual representation of the removal procedure.
Steps
- Remove the two screws (M2x3) that secure the thermal shield and the solid-state drive to the solid-state drive interposer board.
- Slide and lift the thermal shield from the computer base.
- Slide and remove the M.2 2280 solid-state drive from the M.2 solid-state drive slot on the solid-state drive interposer board.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\