Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Alienware Area-51m R2 Service Manual

PDF

Removing the right power-adapter port

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the battery.
  4. Remove the memory modules.
  5. Remove the wireless card.
  6. Remove the solid-state drive from M.2 slot one.
  7. Remove the solid-state drive from M.2 slot two.
  8. Follow the procedure from step 1 to step 4 in Removing the hard drive, if applicable.
  9. Remove the solid-state drive from M.2 slot three, if applicable.
  10. Remove the solid-state drive from M.2 slot four, if applicable.
  11. Remove the solid-state drive interposer board, if applicable.
  12. Remove the rear-I/O cover.
  13. Remove the computer base.
  14. Remove the heat-sink assembly.
  15. Remove the left power-adapter port.
  16. Remove the system board.

About this task

The following image indicates the location of the right power-adapter port and provides a visual representation of the removal procedure.

Image: Removing the right power-adapter port cable

Disconnect the right power-adapter port cable from the connector on bottom side of the system board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\