Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Alienware Area-51m R2 Service Manual

Installing the M.2 2280 solid-state drive in M.2 slot four

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

NOTE: This procedure applies only to computers shipped with an M.2 2280 solid-state drive installed in M.2 slot four.

The following image indicates the location of the M.2 2280 solid-state drive in M.2 slot four and provides a visual representation of the installation procedure.

Image: Replacing the M.2 2280 card

Steps

  1. Align the notch on the M.2 2280 solid-state drive with the tab on the M.2 solid-state drive slot on the solid-state drive interposer board.
  2. Slide the M.2 2280 solid-state drive into the M.2 solid-state drive slot on the solid-state drive interposer board.
  3. Align the screw holes on the thermal shield with the screw holes on the solid-state drive interposer board.
  4. Replace the two screws (M2x3) that secure the solid-state drive and the thermal shield to the solid-state drive interposer board.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\