- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Base cover
- Battery
- Memory modules
- Solid-state drive—M.2 slot one
- Solid-state drive—M.2 slot two
- Solid state drive—M.2 slot three
- Solid state drive—M.2 slot four
- Solid-state drive interposer board
- Wireless card
- Hard drive
- Rear-I/O cover
- Audio daughter-board
- Speakers
- Card-reader board
- Coin-cell battery
- Computer base
- Touchpad
- Display assembly
- Heat-sink assembly
- Processor
- Graphics card
- Left power-adapter port
- System board
- Right power-adapter port
- Keyboard
- Palm-rest assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Alienware
Alienware Area-51m R2 Service Manual
Installing the right power-adapter port
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the right power-adapter port and provides a visual representation of the installation procedure.
Connect the right power-adapter port cable to the connector at the bottom of the system board.
Next steps
- Install the system board.
- Install the left power-adapter port.
- Install the heat-sink assembly.
- Install the computer base.
- Install the rear-I/O cover.
- Install the solid-state drive interposer board, if applicable.
- Install the solid-state drive in M.2 slot four, if applicable.
- Install the solid-state drive in M.2 slot three, if applicable.
- Follow the procedure from step 5 to step 8 in Installing the hard drive, if applicable.
- Install the solid-state drive in M.2 slot two.
- Install the solid-state drive in M.2 slot one.
- Install the wireless card.
- Install the memory modules.
- Install the battery.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\