Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Alienware Area-51 R4 Service Manual

PDF

Procedure

NOTE: Note the routing of all cables as you remove them so that you can route them correctly after you replace the logo board.
  1. Lay the chassis on the right side.
  2. Disconnect all the cables from the logo board.
  3. Remove the screw (#6-32x6) that secures the logo board to the chassis.
  4. Slide the logo board out of the chassis.
    Figure 1. Removing the logo board
    Image: Logo board removal

    1. logo board

    2. connector

    3. screw

  5. Remove the six screws (#6-32x6) that secure the logo board to the bracket.
  6. Remove the logo board from the bracket.
    Figure 2. Removing the logo board
    Image: Logo board removal
    1. screws (6)
    2. logo-board bracket
    3. logo board

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\