Skip to main content

Dell Unity™ Family Unisphere® Command Line Interface User Guide

PDF

Resume replication sessions

Resumes an existing replication session or sessions at the remote level.

Format

/prot/rep/session {–id <value> | -name <value>} resume [-async] [-forceFullCopy] [-allowFullCopy] [-srcSPAInterface <value>] [-dstSPAInterface <value>] [-srcSPBInterface value>] [-dstSPBInterface <value>] [-forceSyncData]

Object qualifiers

Qualifier	Description
-id	Type the ID of the replication session that you want to resume.
-name	Type the name of each replication session that you want to resume.

Action qualifiers

Qualifier	Description
-async	Run an action in asynchronous mode.
-allowFullCopy	This qualifier specifies that a full synchronization can occur if there is no common base snapshot when an asynchronous replication session is resumed. The `-allowFullCopy` option is not supported when a synchronous replication session resumes after a pause operation. The full copy is performed with the same behavior with `-allowFullCopy` specified for synchronous file replication if the session has no common base snapshots, and neither `-allowFullCopy` nor `-forceFullCopy` is specified. If the source system has snapshots that were created before you upgraded your system to Unity 5.1.2 and those snapshots are used as common base snapshots, those snapshots trigger a full synchronization. Beginning with Unity 5.1.2, common base snapshots have signatures that allow delta synchronization to occur. NOTE:This qualifier does not support synchronous block replications.
-forceFullCopy	This qualifier specifies that a full synchronization occurs when an asynchronous replication session is resumed. The `--forceFullCopy` option is not supported when a synchronous replication session resumes after a pause operation. NOTE:This qualifier does not support synchronous block replications.
-srcSPAInterface	Type the ID of the interface on the SPA of the source system for the replication. NOTE:This qualifier is used for asynchronous replications on remote systems only. If the qualifier is not specified, the system identifies the interface automatically.
-dstSPAInterface	Type the ID of the interface on the SPA of the destination system for the replication. NOTE:This qualifier is used for asynchronous replications on remote systems only. If the qualifier is not specified, the system identifies the interface automatically.
-srcSPBInterface	Type the ID of the interface on the SPB of the source system for the replication. NOTE:This qualifier is used for asynchronous replications on remote systems only. If the qualifier is not specified, the system identifies the interface automatically.
-dstSPBInterface	Type the ID of the interface on the SPB of the destination system for the replication. NOTE:This qualifier is used for asynchronous replications on remote systems only. If the qualifier is not specified, the system identifies the interface automatically.
-forceSyncData	This qualifier forces a data transfer from the source system to the remote system. This transfer occurs even if the remote system has data that is not replicated from the source system. NOTE: This qualifier is used for asynchronous replications only.

Example

The following command resumes the replication session 81604378625_FCNCH097274B3A_0000_81604378627_FCNCH097274B37_0000:

uemcli /prot/rep/session –id 81604378625_FCNCH097274B3A_0000_81604378627_FCNCH097274B37_0000 resume

Storage system address: 10.0.0.1
Storage system port: 443
HTTPS connection

ID = 81604378625_FCNCH097274B3A_0000_81604378627_FCNCH097274B37_0000
Operation completed successfully.