Skip to main content

Dell Unity™ Family Unisphere® Command Line Interface User Guide

PDF

Create a LUN move session

Format

/move/session create -srcRes <value> [-srcMemberLun <value>] -targetPool <value> [-priority {idle | low | below | normal | above | high} ] [-thin {yes | no}] [-dataReductionEnabled {yes [-advancedDedupEnabled {yes | no}] | no}] [-async]

Action qualifiers

Qualifier	Description
-srcRes	LUN identifier for a standalone source LUN, or a Consistency Group identifier if moving a LUN that is a member of the Consistency Group.
-srcMemberLun	Source LUN identifier if the LUN is a member of a Consistency Group.
–targetPool	Identifier of the destination storage pool where the moved resources will be created.
-priority	Priority of the move session. Valid values are: idle—Designated for move sessions that continue to mirror the host I/O. low—Designated for move sessions that have the least priority over other move sessions. below—Designated for move sessions that are slightly less critical than the average or normal move session. normal (default)—Designated for move sessions that are appropriate for most use cases. above—Designated for move sessions that are slightly more critical than the average or normal move session. high—Designated for move sessions that take the highest priority over other move sessions.
–thin	Indicates whether to create a thin destination. Valid values are: yes (default) no
-dataReductionEnabled	Indicates whether to create a destination that will have data reduction applied to it. Valid values are: yes no (default)
-advancedDedupEnabled	Indicates whether to create a destination that will have advanced deduplication applied to it. This option only applies when data reduction is enabled. Valid values are: yes no (default)
-async	Run the operation in asynchronous mode.

Example 1

The following command creates a move session.

uemcli -d 10.0.0.1 -u Local/joe -p MyPassword456! /move/session create -srcRes sv_1 –targetPool pool_1 -priority above –thin yes -dataReductionEnabled no

Storage system address: 10.0.0.1
Storage system port: 443
HTTPS connection

ID = move_1
Operation completed successfully.

Example 2

The following command creates a move session, including the source member LUN ID.

uemcli -d 10.0.0.1 -u Local/joe -p MyPassword456! /move/session create -srcRes res_1 -srcMemberLun sv_2 -targetPool pool_2 -priority above -thin yes -dataReductionEnabled yes -advancedDedupEnabled yes

Storage system address: 10.0.0.1
Storage system port: 443
HTTPS connection

ID = move_2
Operation completed successfully.