Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Baskets

Dell Unity™ Family Unisphere® Command Line Interface User Guide

PDF

Change settings for remote storage systems

Changes the configuration settings for a remote system.

NOTE:If a replication connection already exists and you plan to add a different mode of file replication, do not attempt to create a new connection. Change the existing replication connection mode to Both. Also, ensure that you have the appropriate interface types configured to support both asynchronous replication (eth2, eth3) and synchronous replication (sync replication mgmt port).

Format

/remote/sys -id <value> set [-addr <value>] [-dstUsername <value> {-dstPassword <value> | -dstPasswordSecure}] [-connectionType {sync | async | both}] [-bandwidthSchedules <value>]

Object qualifier

QualifierDescription
-idType the ID of the remote system configuration to change.

Action qualifiers

QualifierDescription
-addrType the network name or management IP address of the remote system.
-dstUsernameType the username that is used to access the remote system.
-dstPasswordType the user password that is used to access the remote system.
-dstPasswordSecureSpecify the password in secure mode. The user is prompted to specify the password.
-connectionTypeSpecify this qualifier to indicate the type of replication connection. Valid values are:
  • async
  • sync
  • both
-bandwidthSchedules(async or both connection types only) Specify a schedule during which to cap bandwidth. Type the following to specify the schedule [{Sun|Mon|Tue|Wed|Thu|Fri|Sat}][HH-HH][/<bandwidth>], where:
  • Sun|Mon|Tue|Wed|Thu|Fri|Sat - days of the week to run the schedule
  • HH-HH - start and end time for the schedule
  • /<bandwidth> - value at which to cap bandwidth, in KBps
Leave blank to delete an existing bandwidth schedule.

Example

The following command changes the name, IP address, and access credentials for remote system configuration RS_1:

uemcli -d 10.0.0.1 -u Local/joe -p MyPassword456! /remote/sys –id RS_1 set –addr “10.64.74.2” -dstUsername Local/joe -dstPassword Password456! 
Storage system address: 10.0.0.1
Storage system port: 443
HTTPS connection

ID = RS_1

Operation completed successfully.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\