Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Baskets

Dell PowerEdge T620 Systems Owner's Manual

PDF

Removing The Control Panel—Rack Mode

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  1. If installed, remove the front bezel.
  2. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
  3. Open the system.
  4. Remove the screw securing the control panel to the chassis.
    • CAUTION: Do not use excessive force when removing the control panel as it can damage the connectors.
  5. Disconnect all the cables from the system board to the control panel module.
  6. Slide the control panel module slightly out of the chassis.
  7. Pull up the corner edges of the control panel to disengage the tabs from the slots on the control panel module.
  8. Rotate the left edge of the control panel away from the chassis to release it from the chassis.
    Figure 1. Removing and Installing the Control Panel Module—Rack Mode The figure shows removing and installing the control panel module in the rack mode.
    1. control panel module
    2. screw
    Figure 2. Removing and Installing the Control Panel From the Control Panel Module—Rack Mode The figure shows removing and installing the control panel from the control panel module in the rack mode.
    1. control panel
    2. control panel cable
    3. control panel USB cable

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\