Windows 10
IOT Enterprise LTSB 2016 basic functions
BIOS update
Download BIOS updates for the
Edge Gateway from www.dell.com/support. The download includes
an executable file that may be run from the local machine. For
more information about updating the BIOS, see Accessing and updating
the BIOS.
Watchdog Timer
The Watchdog Timer for Windows 10 IoT Enterprise LTSB 2016 is controlled
through the BIOS setting.
Enter the BIOS during boot by pressing
F2.
The Watchdog Timer is enabled and disabled
under the BIOS setting Watchdog Timer.
NOTE: For more information
about BIOS settings on the Edge Gateway, see Default BIOS settings.
Cloud LED
NOTE: To utilize the Cloud
LED, download the necessary tools and drivers from www.dell.com/support.
One unique feature of the Edge Gateway 3000 Series is the Cloud LED. Cloud LED enables you to visually inspect the operational
status of the Edge Gateway by looking at the display light on the
left panel of the Edge Gateway.
To enable this feature,
you must expose and program a GPIO register on the Edge Gateway.
Follow these steps to control the Cloud LED on the
Edge Gateway:
Click Start > Power, and then click Restart or Shutdown to restart
or shutdown the Edge Gateway, respectively.
LAN and WLAN network
configuration
In the Search box, type Settings and open the Settings window. Select Network & Internet to
configure the network.
Bluetooth configuration
In the Search box, type Settings and open the Settings window. Select Devices, and then select Bluetooth from the menu on the left panel to configure the network.
WWAN (5815) network
configuration
NOTE: Ensure that the micro-SIM
card is already activated by your service provider before using it
in the Edge Gateway. For more information, see activate your mobile
broadband service.
Follow these steps after installing
the micro-SIM card:
In the Search box, type Settings and open the Settings window.
Select Network & Internet.
Locate the WWAN connection in the Wi-Fi section and
select the entry to connect and disconnect from the WWAN adapter.
Ethernet
configuration
In the Search box, type Settings and open the Settings window.
Select Network & Internet.
Select Ethernet, then Change adapter options to change Ethernet settings such as the duplex configuration.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\