The deployment credentials allow you to set
up credentials to communicate securely with a bare-metal system that
is discovered using auto discovery until the OS deployment is complete.
For secure communication with iDRAC, OMIVV uses deployment credentials
from initial discovery until the end of the deployment process. Once
the OS deployment process is successfully complete, OMIVV changes
the iDRAC credentials as provided in the connection profile. If you
change the deployment credentials, all newly discovered systems from
that point onwards are provisioned with the new credentials. However,
the credentials on servers that are discovered prior to the change
of deployment credentials are not affected by this change.
About this task
NOTE OMIVV acts as a provisioning
server. The deployment credentials allow you to communicate with iDRAC
that uses the OMIVV plug-in as a provisioning server in the auto discovery
process.
Steps
In OpenManage Integration for VMware vCenter,
on the Manage > Settings tab, under Appliance Settings, at the right side of Deployment Credentials, click the icon.
In Credentials for Bare Metal Server
Deployment, under Credentials,
enter the values for the following:
In the User Name text box,
enter the user name.
The user name should be 16 characters
or less (only ASCII printable characters).
In the Password text box,
enter the password.
The password should be 20 characters
or less (only ASCII printable characters).
In the Verify Password text
box, enter the password again.
Ensure that the passwords
match.
To save the specified credentials, click Apply.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\