The enclosure
supports up to two switches or pass-through modules. The maximum width
for an Ethernet pass-through module is eight lanes.
The following
I/O modules are supported on the enclosure:
Dell PowerEdge FN 410S I/O Module
Dell PowerEdge FN 410T I/O Module
Dell PowerEdge FN2210S I/O Module
PowerEdge FX2 and FX2s 1 Gb x8 RJ45 pass-through
module
PowerEdge FX2 and FX2s 10 Gb x8 SFP+ pass-through
module
The 10 Gb pass-through module supports both 10 GbE
SFP+ and 1 GbE SFP optical module. The 10 Gb pass-through module supports
1 Gb and 10 Gb connections.
Use SFP+ to configure 10 Gb pass-through module
and SFP or 1 Gb TOR switch to configure 1 Gb pass-through module.
Using a dual-rate optical module for a 1 GbE connection
on the 10 Gb pass-through module results in an invalid link.
Use a dual-rate SFP+ optical module to configure
a 10 GbE connection.
To establish optical links between two 10 Gb pass-through
modules, an external rack switch must be used as an intermediary.
Direct optical connection (using SFP modules, SFP+ modules, and Directed
Attach Copper cables) between two 10 Gb pass-through modules is not
supported.
NOTE: This
restriction is not applicable for Direct Attach Copper connections
or to the 1 Gb pass-through module.
NOTE: For more
information on the I/O modules, see the I/O module documentation at Dell.com/poweredgemanuals.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\