Prerequisites
CAUTION: Many
repairs may only be done by a certified service technician. You should
only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by
Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: To prevent
damage to the I/O connectors, do not touch the connectors or the connector
pins.
CAUTION: To prevent damage to the sled locks, use a #2 Phillips
screwdriver to turn the sled locks to lock or unlock positions.
NOTE: Install the
storage sleds in the bottom slots of the PowerEdge FX2s enclosure,
beginning from the left (slot 3). In the four-bay chassis, you can
also install a storage sled in the top right slot (slot 2) of the
enclosure. For more information on sled slot numbering, see the Dell PowerEdge FX2 and FX2s Enclosure Owner's Manual at Dell.com/poweredgemanuals.
NOTE: If your
storage sled has shipped pre-installed in the enclosure, it is recommended
that you remove the sled before installing the enclosure in the rack,
to reduce chassis weight.
NOTE: If you are installing
the storage sled in an enclosure that is already powered on, you need
not turn off the enclosure to install the storage sled. Only the compute
sled(s) to which the storage sled is mapped must be turned off.
- Ensure that you read the Safety instructions.
- Turn off the compute sled to which the storage sled
is mapped, by using the CMC, iDRAC, or the power button on the compute
sled.
- Keep the #2 Phillips screwdriver ready.