Editing the
default partition configuration values
Perform the
following steps to edit the default partition configuration default
values, as necessary:
Edit the default utility partitioning variable (DT_PARTN_UP), if necessary. Set this variable f you want
to install the Dell utility partition.
Edit the default variable value for the default hard drive
(DT_HD for Windows and DT_HD for Linux), if applicable.
NOTE: Ensure
that the default variable value for DT_HD is set
to a valid non‑removable disk, and not to removable media such as
virtual media.
Edit the default variable value (DT_DP_SIZE in MB for BIOS mode and DT_DP_SIZE_GPT in MiB
for UEFI mode) for the primary operating system partition, if applicable.
Edit the default variable value for file system type ( DT_OS_FSTYPE), if applicable.
NOTE: The valid
values are FAT32 and NTFS.
If the DT_PARTN_UP variable is set to ON, edit the default variable value (in MB) for the utility
partition (DT_UP_SIZE), if applicable.
If the DT_PARTN_UP variable is set to ON, edit the default variable value for the utility partition
installation package location (DT_UP_IMAGE=%DT_SYSTEMS%\UPIMG.BIN for Windows and DT_UP_IMAGE=$dt_systems/upimg.bin for Linux), if applicable.
NOTE: Edit the UPIMG_BIN variable only if you have changed the name
or path of the utility partition installation package.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\