Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Precision 7960 Tower Service Manual

Installing the air shroud

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the air shroud and provides a visual representation of the installation procedure.

Installing the front bezel

Steps

  1. Align the air shroud over the heat-sink and system board holding and seat it in the slot.
  2. Press the air shroud down until the tabs clicks into place.

Next steps

  1. Install the left-side cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\