- Notes, cautions, and warnings
- Additional Resources
- Volumes
- Volume groups overview
- Hosts and host group configurations
- Data mobility for volumes and volume groups
- Thin clones
- Quality of Service (QoS) policies
- Performance policies
Dell PowerStore Configuring Volumes
Map volumes in a volume group to a host
You can map multiple volumes that are members of a volume group to a host or host group.
About this task
Mapping a host to a volume group is enabled for convenience. The mapping is performed for the individual volumes within the group and not to the volume group object itself.
The following restrictions apply:
- After a volume is mapped to a host, it shares the same storage protocol (SCSI or NVMe) as the host to which it is mapped.
- Mixed protocols are not supported.
Steps
-
From
, check the box next to the
volume group that you want to map to a host.
NOTE:Mapping can be done only for one volume group at a time.
- Select to open the Map Hosts slide-out panel.
- Select any hosts that you want the volume group to be mapped to.
- Click Apply.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\