Displays the mismatch (if any), between the VLT peer for the DHCP relay options configuration on the Global level, VRF levels, and VLANs spanned across the VLT peers.
Syntax
show vlt
vlt-domain mismatch dhcp-relay
Parameters
None.
Defaults
None
Command Mode
EXEC
Usage Information
This command shows the mismatch in the
global ip dhcp-relay vss and
ip dhcp-relay server-override commands.
This command shows the codes for the mismatch between the VLT peers for the server-override configuration and
vss-info values for the spanned VLANs or virtual-networks. This command also displays the presence or absence of VRF or interface level source-interface configurations whenever the interface IP address on the client-facing interface is not present.
This command is restricted to
netadmin and
sysadmin role users.
Example (Interface)
OS10(conf-if-po-20)# do show vlt 100 mismatch dhcp-relay
Global relay Configuration Mismatch
------------------------------------------------------------------
VLT Unit ID Link-Selection Server-Override VSS
------------------------------------------------------------------
* 1 enabled - disabled
2 disabled - enabled
VRF relay Configuration Mismatch
-------------------------------------------------------------------
VRF : VRF_RED
VLT Unit ID Source-Interface
-----------------------------------
* 1 Present
2 Not Present
Interface Relay Configuration Mismatch
---------------------------------------------------------------------
VLAN: 10
VLT Unit ID Server-Override VSS Source-Interface
---------------------------------------------------------------------
* 1 enabled type-0(Red) -
2 disabled type-0(Blue) -
VNI: 20
VLT Unit ID Server-Override VSS Source-Interface
----------------------------------------------------------------------
* 1 - type-0(Red) Present
2 - type-1(ABC:1234) Not Present
Supported Releases
10.5.2 or later
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\