NOTE: Certain micro SD cards have a physical write-protect power on the card. If the write-protect switch is turned on, the micro SD card is not writable.
NOTE: IDSDM and vFlash slots are not hot-pluggable.
Steps
Enter System Setup, and ensure that the
Internal SD Card Port is enabled.
Turn off the
system, including any attached peripherals, and disconnect the
system from the electrical outlet.
Remove the
system cover.
NOTE: When an SD card failure occurs, the internal dual SD module controller notifies the
system. On the next restart, the
system displayed a message indicating the failure. If redundancy is enabled at the time of SD card failure, a critical alert is logged and chassis health will degrade.
Replace the failed micro SD card with a new micro SD card.
Install the
system cover.
Reconnect the
system to its electrical outlet and turn on the
system, including any attached peripherals.
Enter System Setup, and ensure that the Internal SD Card Port and
Internal SD Card Redundancy modes are set to the needed modes.
Verify that the correct SD slot is set as
Primary SD Card.
Check if the micro SD card is functioning properly.
If the
Internal SD Card Redundancy option is set to
Enabled at the time of the SD card failure, the
system prompts you to perform a rebuild.
NOTE: The rebuild is always sourced from the primary SD card to the secondary SD card.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\