Dell Secured Component Verification Version 1.5,1.5.1,1.6,1.7,1.8, 1.9, 1.91.0, 1.92.0, and 1.93.0 Reference Guide for Servers and Chassis

System Requirements

Table 1. System requirements for running SCVThis table shows the system requirements for running SCV in the system.

Category

Requirement

Supported operating platforms

WinPE 10.x, Red Hat Enterprise Linux 9.0, Red Hat Enterprise Linux 8.6, SUSE Linux Enterprise Server 15 SP4, Windows Server 2019, and Windows Server 2022.

Firmware versions

iDRAC 5.10.30.00 and later versions
OME-M 2.00.00 and later versions
PowerEdge BIOS 2.14.2 and later versions

Licenses required

Secured Component Verification License

Compatible versions


SCV Version	iDRAC Version
1.93.0	7.10.50.00
1.92.0	7.10.30.00
1.91.0	7.10.30.00
1.9.0	7.00.30.00
1.8.0	6.10.80.00
1.6.0	6.00.30.00
1.5.0	5.10.30.00

SCV 1.91.0 and later versions are backward compatible with any version of iDRAC. However, SCV 1.90.0 and earlier versions are compatible only with version 7.00.30.00 and earlier versions of iDRAC.

NOTE:To get the supported systems list for an SCV version, see the Supported Systems section in the release notes.

NOTE:Red Hat Enterprise Linux 7.x is not supported by SCV 1.6 and later versions.

NOTE:In SCV version 1.5, TPM mismatch is displayed while validating components on a server with an older iDRAC and BIOS firmware. Before running SCV, ensure that the iDRAC firmware is upgraded to version 5.10.30.00, and the BIOS firmware is upgraded to version 2.14.2 or any later versions.

Welcome

Welcome to Dell

Dell Secured Component Verification Version 1.5,1.5.1,1.6,1.7,1.8, 1.9, 1.91.0, 1.92.0, and 1.93.0 Reference Guide for Servers and Chassis

System Requirements

Rate this content