- Notes, cautions, and warnings
- Revision history
- Introduction
- System overview
- Initial setup and configuration
- Pre-operating system management applications
- Replacement of hardware components
- System diagnostics and indicator codes
The system health and system ID indicator is located on the left control panel of the system.
System health and system ID indicator code | Condition |
---|---|
Solid blue | Indicates that the system is powered on, is healthy, and system ID mode is not active. Press the system health and system ID button to switch to system ID mode. |
Blinking blue | Indicates that the system ID mode is active. Press the system health and system ID button to switch to system health mode. |
Solid amber | Indicates that the system is in fail-safe mode.
If the problem persists, see Dell Technologies Support. |
Blinking amber | Indicates that the system is experiencing a fault. Check the System Event Log for specific error messages. For information about the event and error messages generated by the system firmware and agents that monitor system components, go to qrl.dell.com > , type the error code, and then click Look it up. |