- Notes, cautions, and warnings
- Revision history
- Introduction
- System overview
- Initial setup and configuration
- Pre-operating system management applications
- Replacement of hardware components
- System diagnostics and indicator codes
Dell VxRail E660, E660F, and E660N Installation and Service Manual
Log in to iDRAC
You can log in to iDRAC as the following users:
- iDRAC user
- Microsoft Active Directory user
- LDAP user
If secure default access to iDRAC is used, the iDRAC secure default password is available on the back of the appliance Information tag. If you have not opted for secure default access to iDRAC, then the default user name and password are root and calvin. You can also log in by using Dell SSO or Smart Card.
The following prerequisites are a must to log in to iDRAC:
- You must have iDRAC credentials.
- Ensure that you change the default user name and password after setting up the iDRAC IP address.
The iDRAC IP address is pre-configured for DHCP. This can be changed to a static IP address by logging into iDRAC.
- To access iDRAC, connect the network cable to the Ethernet connector 1 on the system board.
- Ensure that you change the default username and password after setting up the iDRAC IP address.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\