- Notes, cautions, and warnings
- Revision history
- Introduction
- System overview
- Initial setup and configuration
- Pre-operating system management applications
- Replacement of hardware components
- System diagnostics and indicator codes
The iDRAC Direct LED indicator lights up to indicate that the port is connected and is being used as a part of the iDRAC subsystem.
You can configure iDRAC Direct by using a USB to micro USB (type AB) cable, which you can connect to your laptop or tablet. Cable length should not exceed 3 feet (0.91 meters). Performance could be affected by cable quality. The following table describes iDRAC Direct activity when the iDRAC Direct port is active:
iDRAC Direct LED indicator code | Condition |
---|---|
Solid green for two seconds | Indicates that the laptop or tablet is connected. |
Blinking green (on for two seconds and off for two seconds) | Indicates that the laptop or tablet connected is recognized. |
LED Indicator off | Indicates that the laptop or tablet is unplugged. |