- Notes, cautions, and warnings
- Revision history
- Introduction
- System overview
- Initial setup and configuration
- Pre-operating system management applications
- Replacement of hardware components
- System diagnostics and indicator codes
The LEDs on the drive carrier indicate the state of each drive. Each drive carrier has two LEDs: an activity LED (green) and a status LED (bicolor, green/amber). The activity LED blinks whenever the drive is accessed.
Drive status indicator code | Condition |
---|---|
Blinks green twice per second | Indicates that the drive is being identified or preparing for removal. |
Off | Indicates that the drive is ready for removal.
NOTE:The drive status indicator remains off until all drives are initialized after the system is powered on. Drives are not ready for removal during this time.
|
Blinks green, amber, and then powers off | Indicates that there is an unexpected drive failure. |
Blinks amber four times per second | Indicates that the drive has failed. |
Blinks green slowly | Indicates that the drive is rebuilding. |
Solid green | Indicates that the drive is online. |
Blinks green for three seconds, amber for three seconds, and then powers off after six seconds | Indicates that the rebuild has stopped. |