- Notes, cautions, and warnings
- Revision history
- Introduction
- System overview
- Initial setup and configuration
- Pre-operating system management applications
- Replacement of hardware components
- System diagnostics and indicator codes
Dell VxRail E660, E660F, and E660N Installation and Service Manual
System overview
An overview of the support capabilities of the VxRail E660 series.
VxRail E660 and E660F are a 1U server that supports:
- Up to two 3rd Generation Intel Xeon Scalable processors, with up to 40 cores per processor
- 32 DIMM slots
- Two fault tolerant redundant (FTR) AC power supply units
- Up to 10 x 2.5-inch drives (with two universal slots to support optional NVMe drives).
VxRail E660F supports DPU/SmartNIC.
VxRail E660N is a 1U server that supports:
- Up to two 3rd Generation Intel Xeon Scalable processors, with up to 40 cores per processor
- 32 DIMM slots
- Two FTR AC power supply units
- Up to 10 x 2.5-inch all NVMe drives
You cannot mix different capacity drives in VxRail E660N.
VxRail E660N vSAN ESA (Express Storage Architecture) supports:
- In the DIMM configuration, the minimum supported RAM capacity is 128 GB for systems with both single and dual processors
- vSAN ESA configuration supports a minimum of 4 drives and a maximum of 10 drives.
- Supports 10/25/100 Gbps Network Interface Controller (NIC) ports
- Minimum cores supported is 16 cores per processor.
NOTE:All instances of drives in this document indicate SAS, SATA, NVMe drives, unless specified otherwise.
For more information about supported drives, see the Dell VxRail E660, E660F, and E660N Technical Specifications.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\