Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.4

PDF

sync-e hold-off-time

Configures hold-off time interval.

Syntax
[no] sync-e hold-off-time milliseconds
Parameters
milliseconds—Enter the hold-off time interval in milliseconds, from 300 to 1800.
Default
300
Command Mode
  • CONFIGURATION
  • INTERFACE CONFIGURATION
Security and Access
Netadmin and sysadmin
Usage Information
This command enables hold-off time for the SyncE interfaces. The hold-off-time is the time period for which the switch waits before removing the clock source from the clock selection process when it goes down. The clock selection process is triggered after the hold-off time to select the new synchronization clock source. The switch might be in holdover state during the reference switch from one clock source to another. In QL-disabled mode, signal fail is sent to the selection process after the hold-off time. In QL-enabled mode, QL value of QL-FAILED signal is sent to the selection process after the hold-off time. In the meantime, previous QL value is passed to selection process. QL values other than QL-FAILED is passed to selection process immediately. The interface level hold-off-time value takes precedence over the global hold-off-time value. The no form of this command removes the configuration.
Example - Global level 
OS10(config)# sync-e hold-off-time 400
Example - Interface level 
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# sync-e hold-off-time 500
Supported Releases
10.5.2.1 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\