Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.4

PDF

show sync-e interface

Displays the SyncE configuration and status of a specific interface or all interfaces.

Syntax
show sync-e interface [ethernet node/slot/port]
Parameters
ethernet node/slot/port—(Optional) Enter a physical Ethernet interface.
Default
None
Command Mode
EXEC
Usage Information
This command prints output only when SyncE is enabled globally and on the interfaces.
Example - QL-enabled mode 
OS10# show sync-e interface ethernet 1/1/1 
Interface : Ethernetl/1/1
  SyncE                : Enabled
  State                : Available
  Status               : Primary
  Signal State         : Up
  Priority             : 128
  ESMC Capability      : Rx and Tx
  QL                   : QL-SSU-A
  QL Received          : QL-SSU-A
  QL Transmitted       : QL-DNU
  Hold-off Time        : 300 ms
  Wait-To-Restore Time : 5 secs
Example - QL-disabled mode 
OS10# show sync-e interface 
Interface : Ethernetl/1/1
  SyncE                : Enabled
  State                : Available
  Status               : Secondary
  Signal State         : Up
  Priority             : 128
  ESMC Capability      : -
  QL                   : -
  QL Received          : -
  QL Transmitted       : -
  Hold-off Time        : 300 ms
  Wait-To-Restore Time : 300 secs
Interface : Ethernetl/1/2
  SyncE                : Enabled
  State                : Available
  Status               : Primary
  Signal State         : Up
  Priority             : 128
  ESMC Capability      : -
  QL                   : -
  QL Received          : -
  QL Transmitted       : -
  Hold-off Time        : 300 ms
  Wait-To-Restore Time : 300 secs
Supported Releases
10.5.2.1 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\