Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.4

PDF

ptp clock-mode

Configures the time stamping mode on PTP clock to either one-step or two-step.

Syntax
[no] ptp clock-mode [one-step | two-step]
Parameters
  • one-step—Enables one-step mode to send the timestamp with the synchronous message.
  • two-step—Enables two-step mode to send a synchronous message followed by a follow-up with the timestamp.
Defaults
One-step mode
Command Mode
CONFIGURATION
Security and Access
Netadmin and sysadmin
Usage Information
The time stamping mode configuration is not applicable on the slave port of a boundary clock. However, slave port can process the messages from both one-step and two-step clocks. The time stamping mode configuration is not applicable on the transparent clock. The no form of this command removes the configuration.
Example 
OS10(config)# ptp clock-mode two-step

OS10(config)# no ptp clock-mode
Supported Releases
10.5.4.2 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\