Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.4

PDF

ptp announce

Configures the interval between successive announce messages and the timeout for the message.

Syntax
ptp announce {[interval log2-seconds] | [timeout multiplier]}
Parameters
  • log2-seconds—Configures the logarithmic time interval in seconds between successive announce messages. For the system default profile, enter a value from -2 to 4 (1/4 s to 16 s). For the ITU G.8275.1 profile, only -3 (1/8 s) is the supported value.
  • multiplier—Configures the count of announce message intervals that have to pass without receipt of an announce message to declare a timeout. For the system default profile, enter a value from 2 to 10 (default value is 3). For the ITU G.8275.1 profile, enter a value from 3 to 10 (default value is 3).
Defaults
  • Interval:
    • System default profile: 1
    • ITU G.8275.1 profile: -3
  • Timeout: 3
Command Mode
INTERFACE CONFIGURATION
Security and Access
Netadmin and sysadmin
Usage Information
When a timeout event occurs, the system selects a port with dynamic role to be the master. The no form of this command removes the configuration.
Example (system default profile) 
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# ptp announce interval 1
OS10(conf-if-eth1/1/1)# ptp announce timeout 5
Supported Releases
10.5.1.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\