Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.4

PDF

ipv6 pim dr-priority

Enables the PIM sparse-mode operation.

Changes the designated router (DR) priority of the interface.

Syntax
ipv6 pim dr-priority priority-value
Parameters
dr-priority priority-value—Enter a priority number. Larger numbers are given preference over smaller numbers. The range is from 0 to 4294967295.
Default
1
Command Mode
INTERFACE CONFIGURATION
Usage Information
This command allows you to specify the DR priority of each interface on the LAN segment so that the interface with the highest priority is elected as the PIM DR. If all devices on the LAN segment have the same priority, and then the PIM device with the highest IPv6 address becomes the DR. Use the no ipv6 pim dr-priority priority-value command to remove this configuration.
Example 
OS10(conf-if-vl-2001)# ipv6 pim dr-priority 100
Supported Releases
10.5.4.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\