Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.4

PDF

ipv6 nd max-ra-interval

Sets the maximum time interval between sending RA messages.

Syntax
ipv6 nd max-ra-interval seconds
Parameters
  • max-ra-interval seconds—Enter a time interval in seconds, from 4 to 1800.
Defaults
600 seconds
Command Mode
  • CONFIGURATION
  • INTERFACE
Usage Information

If you are configuring auto-unnumbered BGP neighbors, use this command in CONFIGURATION mode. Dell Technologies recommends that you configure the maximum RA timer to four seconds auto-unnumbered BGP neighbors.

If you configure this command both globally and on an interface, the configuration on the interface takes precedence.

The no version of this command restores the default time interval that is used to send RA messages.

Example 
OS10(config)# interface ethernet 1/2/3
OS10(conf-if-eth1/2/3)# ipv6 nd max-ra-interval 300
OS10(config)# ipv6 nd max-ra-interval 4
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\