Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.4

PDF

ip pim sparse-mode

Enables PIM sparse mode and IGMP on the interface.

Syntax
ip pim sparse-mode
Parameters
None
Default
Disabled
Command Mode
INTERFACE CONFIGURATION
Usage Information
Before you enable PIM sparse mode, ensure that:
  • Multicast is enabled globally using the ip multicast-routing command.
  • The interface is enabled. Use the no shutdown command to enable the interface.
  • The interface is in Layer 3 mode. PIM-SM is enabled only on a Layer 3 interface. Before configuring PIM on the interface, use the no switchport command to change the interface from Layer 2 to Layer 3 mode.

Use the no form of the command to disable PIM sparse mode.

Example
OS10# configure terminal
OS10(config)# interface vlan 2
OS10(conf-if-vl-2)# ip address 1.1.1.2/24
OS10(conf-if-vl-2)# ip pim sparse-mode
Supported Releases
10.4.3.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\