Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.4

PDF

ip local-proxy-arp

Enables the local proxy Address Resolution Protocol (ARP) on an interface.

Syntax
ip local-proxy-arp
Parameters
None
Default
Not applicable
Command Mode
VLAN INTERFACE CONFIGURATION
Usage Information
  • The router responds to ARP requests for addresses that are on the same subnetwork of that interface.
  • This command is applicable only for the primary VLAN.
  • Ensure that you configure an IPv4 address on the primary VLAN before you enable local proxy ARP.
  • In a VLT setup, you must configure this command on both the primary and secondary VLT nodes. The secondary VLT node suppresses the local proxy ARP functionality.
  • The no form of this command disables the local proxy ARP functionality.
Example—To enable local proxy ARP in a VLAN. 
OS10(conf-if-vl-10)# ip local-proxy-arp
Supported Releases
10.5.2.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\