Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.4

PDF

Configure trunk port

To create a stack VLAN and configure trunk port:

  1. Enter the CONFIGURATION mode. 
    OS10# configure terminal
OS10(config)#
  2. Create a VLAN to assign as service provider VLAN. 
    OS10(config)# interface vlan 100
OS10(conf-if-vl-100)#
  3. Configure the VLAN as a stack VLAN. 
    OS10(conf-if-vl-100)# vlan-stack
  4. Exit the INTERFACE-VLAN mode. 
    OS10(conf-if-vl-100)# exit
OS10(config)#
  5. Enter the INTERFACE CONFIGURATION mode. 
    OS10(config)# interface ethernet 1/1/5
OS10(conf-if-eth1/1/5)#
  6. Set the switchport to trunk mode. 
    OS10(conf-if-eth1/1/5)# switchport mode trunk
  7. Remove access VLAN membership. 
    OS10(conf-if-eth1/1/5)# no switchport access vlan
  8. Configure the TPID value.
    NOTE: This value is used in the S-Tags. 
    OS10(conf-if-eth1/1/5)# switchport trunk tpid 9100
  9. Assign the port to the service provider VLAN as a trunk member. 
    OS10(conf-if-eth1/1/5)# switchport trunk allowed vlan 100

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\