Use the
clean-reset command to enable or disable clean reset mode. Enabling or disabling the clean reset mode takes effect only after you reload the device.
Enable clean reset
Enable clean reset mode in EXEC mode.
OS10# clean-reset enable
Warning :
- clean reset feature, if enabled, will get effective only after a new reload is done.
- If enabled, it will lock the file system to read only mode, after next reload.
- Can be enabled only on platforms supporting UEFI BIOS
- Can use 'show clean-reset status' for displaying status
- Post reload,all features which require saving onto persistent storage will not work.
- Some of the features that may not work are given below, though this list may not be
exhaustive:
- Saving running configuration to startup configuration (write memory command)
- Image Upgrade/downgrade (image install/uninstall command )
- Secured Image Upgrade/downgrade (image secure-install command)
- The secure-boot file system integrity check validation will be skipped, if
secure boot were enabled (secure-boot enable)
For these features to work again, feature has to be disabled using clean reset disable and device reloaded:
Do you still want to enable clean reset feature ? [yes/no(default)]:yes
OS10#
Reload the device.
OS10# reload
Disable clean reset
Disable clean reset mode in EXEC mode.
OS10# clean-reset disable
Reload the device.
OS10# reload
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\
