Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.4

PDF

Configure access port

To create a stack VLAN and configure access port:
  1. Enter the CONFIGURATION mode. 
    OS10# configure terminal
OS10(config)#
  2. Create a VLAN to assign as service provider VLAN. 
    OS10(config)# interface vlan 10
OS10(conf-if-vl-10)#
  3. Configure the VLAN as a stack VLAN. 
    OS10(conf-if-vl-10)# vlan-stack
  4. Exit the INTERFACE-VLAN mode. 
    OS10(conf-if-vl-10)# exit
OS10(config)#
  5. Enter the INTERFACE CONFIGURATION mode. 
    OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)#
  6. Disable spanning tree on the port. 
    OS10(conf-if-eth1/1/1)# spanning-tree disable
  7. Assign the port to the stack VLAN access group. 
    OS10(conf-if-eth1/1/1)# switchport access vlan 10

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\