Dell PowerFlex Rack with PowerFlex 3.x Administration Guide

Configure static bonding NIC port design network settings in PowerFlex Manager templates

Perform this procedure to configure network settings in PowerFlex Manager for static bonding NIC port design. This design supports up to two data networks.

1. Clone the template:
   1. On the PowerFlex Manager menu bar, click Templates and then click Add a Template.
   2. In the Add a Template wizard, click Clone an existing PowerFlex Manager template.
   3. From the Category list, select Sample Templates.
   4. From the Template to be Cloned list, select the template that matches the service you want to deploy. Click Next.
   5. On the Template Information page, enter the template name. Select Create New Category from the Template Category list.
   6. Enter Prod in the New Category Name and specify the Firmware and Software Compliance and specify the service permissions for the template under Who should have access to the service deployed from this template. Click Next.
   7. On the Additional Settings page, provide new values for network settings, OS settings, cluster settings, PowerFlex gateway settings, and node pool settings.
   8. Click Finish. The cloned template is added to the list on the Templates page.
2. Click the cloned template.
3. Click the node icon and click Edit.
4. Verify the number of nodes to deploy and click Continue.
5. For PowerFlex compute-only nodes, edit the parameters for the network configuration as follows:
   1. Under OS Settings > Switch Port Configuration, select Port Channel.
   2. Under Network Settings > Interfaces, enter the following details:
      NOTE:For a multi-subnet or multi-VLAN configuration, ensure to add all the networks for each required network type.
      • Interface 1 > Port 1 > Network (VLAN): flex-node-mgmt, flex-vmotion, and PXE
      • Interface 1 > Port 2 > Network (VLAN): data network1, data network2
      • Interface 2 > Port 1 > Network (VLAN): flex-node-mgmt, flex-vmotion, and PXE
      • Interface 2 > Port 2 > Network (VLAN): data network1, data network2

6. For PowerFlex hyperconverged nodes, edit the parameters for the network configuration as follows:
   1. Under OS Settings > Switch Port Configuration, select Port Channel .
   2. Under Network Settings > Interfaces, enter the following details:
      NOTE:For a multi-subnet or multi-VLAN configuration, ensure to add all the networks for each required network type.
      • Interface 1 > Port 1 > Network (VLAN): flex-node-mgmt, flex-stor-mgmt, flex-vmotion, and PXE
      • Interface 1 > Port 2 > Network (VLAN): data network1, data network2
      • Interface 2 > Port 1 > Network (VLAN): flex-node-mgmt, flex-stor-mgmt, flex-vmotion, and PXE
      • Interface 2 > Port 2 > Network (VLAN): data network1, data network2

7. For PowerFlex storage-only nodes, edit the parameters for the network configuration as follows:
   1. Under OS Settings > Switch Port Configuration, select Port Channel.
   2. Under Network Settings > Interfaces, enter the following details:
      NOTE:For a multi-subnet or multi-VLAN configuration, ensure to add all the networks for each required network type.
      • Interface 1 > Port 1 > Network (VLAN): flex-stor-mgmt, data network1, and PXE
      • Interface 1 > Port 2 > Network (VLAN): data network2
      • Interface 2 > Port 1 > Network (VLAN): flex-mgmt, data network1, and PXE
      • Interface 2 > Port 2 > Network (VLAN): data network2