Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

zoneset activate

Activates an existing zoneset. You can activate only one zoneset in a vfabric.

Syntax
zoneset activate zoneset-name
Parameters
zoneset-name — Enter an existing zoneset name.
Defaults
Not configured
Command Mode
vfabric CONFIGURATION
Usage Information

After you disable an active zoneset, the zone default-zone permit command configuration takes effect. Based on this configuration, the default zone allows or denies access between all the logged-in FC nodes of the vfabric. The no version of this command deactivates the zoneset.

Supported on the MX9116n switch in Full Switch mode starting in release 10.4.1.0. Also supported in SmartFabric mode starting in release 10.5.0.1.

Example 
OS10(config)# vfabric 100
OS10(conf-vfabric-100)# zoneset activate set
Supported Releases
10.3.1E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\