Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

unit-provision

Provisions the unit ID of a Fabric Expander attached to an MX9116n Fabric Switching Engine in Full Switch mode.

Syntax
unit-provision node/unit-id provision_name
Parameters
  • node/unit-id — Enter 1 for node with an unassigned unit ID displayed in the show unit-provision output.
  • provision_name — Enter the service tag of the Fabric Expander displayed in the show discovered-expanders output.
Default
None
Command Mode
CONFIGURATION
Usage Information
  • To verify the currently configured mode on a Fabric Engine, use the show switch-operating-mode command. If a Fabric Engine is in Full Switch mode, you must manually provision a Fabric Expander using the unit-provision command. This command assigns a unit ID to a service tag or provision name. To transmit server traffic, you must configure the virtual port on the Fabric Expander by entering the unit ID as the virtual-slot number using the interface ethernet node/virtual-slot/port command.
  • The no version of the command removes the Fabric Expander provisioning.
Example 
OS10(config)# unit-provision 1/78 403RPK2
Supported Releases
10.4.0E(R3S) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\