Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

source

Configures a source for port monitoring. The monitoring session can be: local, RPM, or ERPM.

Syntax
source interface interface-type {both | rx | tx}
Parameters
  • interface-type—Enter the interface type:
    • ethernet node/slot/port[:subport]—Enter the Ethernet interface information as the monitored source.
    • port-channel id-number—Enter the port-channel interface number as the monitored source, from 1 to 128.
    • vlan vlan-id—Enter the VLAN identifier as the monitored source, from 1 to 4093.
  • both—Monitor both receiving and transmitting packets. This option is not supported on VLAN interfaces.
  • rx—Monitor only received packets.
  • tx—Monitor only transmitted packets. This option is not supported on VLAN interfaces.
Default
Not configured
Command Mode
MONITOR-SESSION
Usage Information
Example 
OS10(config)# monitor session 1
OS10(conf-mon-local-1)# source interface ethernet 1/1/7 rx
OS10(config)# monitor session 5 type rpm-source
OS10(conf-mon-rpm-source-5)# source interface ethernet 1/1/10 rx
OS10(config)# monitor session 10 type erpm-source
OS10(conf-mon-erpm-source-10)# source interface ethernet 1/1/5 rx
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\