Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

smartfabric vlti

Updates the VLTi after SFS is created.

Syntax
smartfabric vlti ethernet ports
Parameters
  • ethernet ports — Specify the ethernet ports on which VLTI needs to be updated.
Default
None
Command Mode
CONFIGURATION
Usage Information

Use this command to configure or update the VLTi information after the SFS is enabled on the node. The system will go for a reload and then comes back up with the configured VLTi ports.

Before executing this command, the node should already be in Layer3 fabric mode. If not, the Layer3 fabric personality should be enabled.

If you use any of the existing ports for the VLTi, those ports should also be specified as part of the VLTi configuration using the smartfabric commands.

Example 
OS10(config)#smartfabric vlti ethernet 1/1/31-1/1/32

Warning:The system will be reloaded now, for the personality changes to take effect
Supported Releases
10.5.0.3 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\