Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

show ip management-route

Displays the IPv4 routes used to access the Management port.

Syntax
show ip management-route [all | connected | dynamic | static summary]
Parameters
  • all — (Optional) Display the IPv4 routes that the Management port uses.
  • connected — (Optional) Display only routes directly connected to the Management port.
  • dynamic — (Optional) Display active management routes that are learned by a routing protocol.
  • summary — (Optional) Display the number of active and non-active management routes and their remote destinations.
  • static — (Optional) Display active static management routes.
Default
Not configured
Command Mode
EXEC
Usage Information
Use this command to view the IPv4 static and connected routes configured for the Management port. Use the management route command to configure an IPv4 or IPv6 management route.
Example 
OS10# show ip management-route
 Destination        Gateway              State       Source
-----------------------------------------------------------------
192.168.10.0/24     managementethernet   Connected   Connected
Supported Releases
10.2.2E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\