Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

sflow source-interface

Configures an interface as source for sFlow. The sFlow agent uses the IP address of the configured source interface as the agent IP address.

Syntax
sflow source-interface {ethernet node/slot/port[:subport] | loopback loopback-ID | port-channel port-channel-ID | vlan vlan-ID}
Parameters
  • ethernet node/slot/port[:subport]—Enter the physical interface type details.
  • loopback loopback-ID—Enter the Loopback interface details. The Loopback ID range is from 0 to 16383.
  • port-channel port-channel-ID—Enter the port channel details. The port channel ID range is from 1 to 128.
  • vlan vlan-ID—Enter the VLAN details. The VLAN ID range is from 1 to 4093.
Default
Disabled
Command Mode
CONFIGURATION
Usage Information

The no version of this command removes the configuration from the interface.

Example (Ethernet)
OS10(config)# sflow source-interface ethernet 1/1/1
Example (Loopback)
OS10(config)# sflow source-interface loopback 1
Example (port-channel)
OS10(config)# sflow source-interface port-channel 1
Example (VLAN)
OS10(config)# sflow source-interface vlan 10
Supported Releases
10.4.1.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\