Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

neighbor

Creates a remote IP peer and enters Neighbor Configuration mode.

Syntax
neighbor ip-address
Parameters
  • ip-address—Enter the IPv4 or IPv6 address of the neighbor.
  • interface interface-type—Enter the interface that connects to an unnumbered neighbor.
  • unnumbered-auto—Configure one or more BGP auto unnumbered neighbors.
Default
Not configured
Command Mode
CONFIG-ROUTER-BGP
Usage Information

Create a remote peer with the BGP neighbor. Always enter the IP address of a BGP peer with this command.

NOTE To configure these settings for a nondefault VRF instance, you must first enter the ROUTER-CONFIG-VRF sub mode using the following commands:
  1. Enter the ROUTER BGP mode using the router bgp as-number command.
  2. From the ROUTER BGP mode, enter the ROUTER BGP VRF mode using the vrf vrf-name command.

The no version of this command disables the BGP neighbor configuration.

Example 
OS10(conf-router-bgp-2)# neighbor 32.1.0.0
OS10(conf-router-neighbor)#
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\