Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

ipv6 virtual-router address

Configures an anycast gateway IPv6 address to a VLAN interface.

Syntax
ipv6 virtual-router address ipv6–address
Parameters
address ipv6–address—Enter the IPv6 address of the anycast L3 gateway.
Default
Not configured
Command mode
INTERFACE-VLAN
Usage information

Using this command, you can configure anycast IP gateway for up to 512 VLANs. The anycast IP address may optionally be configured with a 128-bit subnet mask. Make sure the anycast IP address is different from the primary IP address. To assign an anycast IPv4 address to a VLAN interface, use the ip virtual-router address command.

Prior to assigning the anycast IP address to a VLAN interface, configure a virtual MAC address to the switch using the ip virtual-router mac-address command. All virtual addresses on all VLAN interfaces resolve to the configured virtual MAC address.

The no version of the command removes the specified anycast IPv6 address from the VLAN interface.

Example 
OS10(config)# interface vlan 100
OS10(conf-if-vl-100)# ipv6 virtual-router address 3001::3
Supported releases
10.5.2.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\