Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

ip ospf transmit-delay

Sets the estimated time required to send a link state update packet on the interface.

Syntax
ip ospf transmit-delay seconds
Parameters
seconds — Set the time in seconds required to send a link-state update, from 1 to 3600.
Default
1 second
Command Mode
INTERFACE
Usage Information
When you set the ip ospf transmit-delay value, take into account the transmission and propagation delays for the interface. The no version of this command resets the value to the default.
Example
OS10(conf-if-eth1/1/4)# ip ospf transmit-delay 5
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\