Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

ip ospf hello-interval

Sets the time interval between the hello packets sent on the interface.

Syntax
ip ospf hello-interval seconds
Parameters
seconds — Enter the hello-interval value in seconds, from 1 to 65535.
Default
10 seconds
Command Mode
INTERFACE
Usage Information
All routers in a network must have the same hello time interval between the hello packets. The no version of the this command resets the value to the default.
NOTE When you configure hello-interval for OSPF, the OSPF dead-interval value is implicitly set to a value four times greater than the hello-interval value.
Example
OS10(conf-if-vl-10)# ip ospf hello-interval 30
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\