Dell EMC SmartFabric OS10 User Guide Release 10.5.0

interface range {ethernet node/slot/port[:subport]-node/slot/port[:subport],[...]} | {port-channel IDnumber-IDnumber,[ ...]} | vlan vlanID-vlanID,[...]}

• node/slot/port[:subport]-node/slot/port[:subport] — Enter a range of Ethernet interfaces.
• IDnumber-IDnumber — Enter a range of port-channel numbers, from 1 to 128.
• vlanID-vlanID — Enter a range VLAN ID numbers, from 1 to 4093.

Enter up to six comma-separated interface ranges without spaces between commas. When creating an interface range, interfaces are not sorted and appear in the order entered. You cannot mix interface configuration such as Ethernet ports with VLANs.

• Abulk configuration is created if at least one interface is valid.
• Non-existing interfaces are excluded from the bulk configuration with a warning message.
• This command has multiple port ranges, the prompt excludes the smaller port range.
• If you enter overlapping port ranges, the port range extends to the smallest port and the largest end port.
• You can only use VLAN and port-channel interfaces created using the interface vlan and interface port-channel commands.
• You cannot create virtual VLAN or port-channel interfaces using the interface range command.
• The no version of this command deletes the interface range.

OS10(config)# interface range ethernet 1/1/7-1/1/24
OS10(conf-range-eth1/1/7-1/1/24)#