Dell EMC SmartFabric OS10 User Guide Release 10.5.0

Configure Layer 3 Routed uplink

You can create a L3 Routed uplink and associate a network with the uplink. To do so:

1. Launch the Create Uplink for External Network Connectivity wizard.
2. Select the Uplink Ports Type as Layer 3.
3. Select the Network Type as L3 Routed.
4. Create a L3 Routed uplink by providing the name and description, and click NEXT.
5. Associate an interface from the spine or leaf switch with the L3 Routed uplink.
   • Spine — Select a spine switch and an interface from the spine to associate with the uplink.
   • Leaf — Select a leaf switch from the rack, and an interface from the leaf switch to associate with the uplink.
     NOTE You can select only one interface from the spine or leaf switch for L3 Routed uplink.
6. Create a L3 Routed network to associate by providing a name, description, interface IP address, and prefix length.
7. Define a routing policy to associate with the uplink based on the external network connectivity setup.
   • Static Route — A route policy template that contains a network prefix and the next hop IP address.
   • eBGP — A routing policy template that contains BGP peer IP address and the remote AS number.

You can view and delete a routing profile from the Routing Profiles tab.