Plug-in options enable you to control restore functionality that is specific to the Avamar Plug-in for Windows VSS. You set restore options manually from the
Restore Command Line Options dialog box.
The following table lists options are available when you perform a restore using the Avamar Plug-in for Windows VSS.
Table 1. Windows VSS plug-in restore options
Option
Description
Encryption method from Data Domain system
Specifies the encryption method for data transfer from the Data Domain system to the client during the restore.
Advanced Options
Temporary directory for the plug-in
Temporary folder.
Enable debugging messages
Writes maximum information to the log files. The restore process generates very large log files.
Command line flags
--allow_partial_system_state
Allows partial System State to be restored online. Supported only for Active Directory.
Specify this option by using the
Enter Attribute and
Enter Attribute Value fields on the
Restore Command Line Options dialog box.
--exclude-non-critical-disks= {true | false}
Excludes noncritical disks from disaster recovery preparation so that the disks do not reformat.
Set this flag to
false to work around a disaster recovery failure from configuration changes, such as changes to the dynamic disk configuration.
Use this flag only during offline disaster recovery.
You can specify this option in the Avamar Bare Metal Recovery Wizard by clicking
Options on the
System Recovery Summary page.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\